FRONT PANEL CONTROLS
INPUT
GAIN
-10 dB PAD
COMPRESSOR
COMPRESSION
BOOST
EQ ON
EQ BALANCE
VOICING SECTION:*
BOTTOM
CONTOUR
GROWL
ATTACK
EQ SECTION:*
BASS
MID FREQ.
MID LEVEL
TREBLE
MUTE
MASTER
PHONES
POWER
* Note: after adjusting the voicing section, the BOOST or activating the EQ section the Gain control needs to be adjusted that the level is under the
CLIP point.
socket to plug in a bass guitar.
control + CLIP LED to adjust the input level*.
switch to set the range of the GAIN control. Use it with high output basses.
switch + 2-colored ON/COMPRESS LED to compress the signal.
In position up the compressor is on, in middle position off, in down position it is
on if the EQ section is activated.
control to set the compression ratio.
switch to activate a second volume level. In down position +2dB, in up position
+6dB, in middle poistion the boost is off. Activating the BOOST does automatic
ally activate the Compressor.*
switch activates the EQ section*.
control to balance the volume level with EQ on and EQ off.*
control to extend the low frequency range. Use this at lower volume settings or for
ultra low sounds. At higher volumes it might be better to reduce the low range.
control boosts lows and highs, while cutting mids.
control for boosting/cutting low mids.
control for boosting/cutting presence.
control to boost/cut deep frequencies.
control to determine a frequency.
control to boost/cut the frequency adjusted with the MID FREQ. control.
control to boost/cut high frequencies.
switch + ON/MUTE LED cuts the signal from all outputs, except from the PHONES
socket, and activates the TUNER output (rear panel). In case of signal flow at the
power section (Input or Effects Return), there might appear a popping noise when
MUTE is switched. To avoid this, mute your strings and have effects like delays
muted when switching MUTE.
control determines the mains level.
socket for connecting a headphone (min 200 Ω)
on/off switch for the Mains Power.