Dead Band (Dual Set Points); Change Temperature Setting(Single Set Point) - LG PREMTC00U Manual De Instalación

OPERATION INSTRUCTIONS - Sub Function
14
Press the button for 3 seconds. You can
enter to sub function setting mode and press
the button repeatedly to change the sub
function mode in the following order.
Setback temperature Override time
setting setting
Dead band setting or
Change temperature
setting
Vane angle control
WLAN module
Heater access
point mode
h Some functions may not operate depending
on the product.
h Dead band setting – When it connects with
an dual set points control product.
Change temperature – When it connect
with single set point control product.
Setting the setback temperature
1 Press button for 3 seconds.
2 Press button to move the setback
mode.
3 Press button to select cool/heat
temperature.
4 Press button to change the
temperature.
5 Press button to set temperature.
6 Press button for 3 seconds.
Setting the override time
1 Press button for 3 seconds.
2 Press button to move the override
mode.
3 Press button to select override time.
4 Press button to set override time.
5 Press button for 3 seconds.
h You can set in units of 30 minutes.
OPERATION INSTRUCTIONS - Sub Function

Dead band (Dual set points)

This function sets the minimum difference
between heating and cooling set points.
h This function is used in connection with the
dual set points control product.
1
Press button for 3 seconds.
2
Press button to move the dead band
mode.
3
Press button to change the dead band
temperature. (0 ~ 10°F/0 ~ 5°C)
4 Press button to set temperature.
5 Press button for 3 seconds.
Change temperature setting
(Single set point)
Change temperature is the function to setup
air-cooling and heating drive automatically
changeable according to the temperature at
single set point auto operation mode.
h This function is used in connection with the
single set point control product.
15
1
Press button for 3 seconds.
2
Press button to move the change
temperature setting mode.
3
Press button to change the
temperature. (2 ~ 14°F/1 ~ 7°C)
4
Press button to set temperature.
5 Press button for 3 seconds.
Example of using change temperature
Condition
1) Mode: Auto mode
2) Temperature: 72°F(22°C)
3) Change Temperature: 6°F(3°C)
h In case of the above conditions, it operates
as in the graph.
① : Cooling operation start
② : Heating operation start
Temp(°F/°C)
78°F(25°C)
72°F(22°C)
66°F(19°C)
h This function may not work in some
products.