Hkoenig V24 Manual De Utilización página 11

Around 3 minutes, steam available light (8) will die out, it means the
appliance can be using the steam.
Obtain steam after pressing the steam button (3). Release the button
(3) and the steam flow stops.
This appliance is also able to generate
and can therefore be used to refresh fabrics easily with a jet of
steam.
When you ending the ironing, press the switch button (7), cut down
the power, press the steam button (3) to release the residual steam
in the boiler (13)
NOTE: Continue to release steam for long time, when pump adds
water into boiler, soleplate will stop to release steam for short time,
almost 10secs.
DRYIRONING
Connect the appliance to the mains
button(7), then select the desired temperature by turning the
thermostat knob(4).Wait until the iron heating indicator light (2)
goes off, indicating that the desired temperature has been
reached.
For dry ironing it is not necessary to press the steam button (3).
FILLING THE TANK
Thanks to the self-filling
stop and wait while the boiler fills up again.
When the water in the boiler is at minimum
automatically activated which fills the boiler once
If you hear the loud feed-water sound when you
there is no water in the water tank (14).Press the switch button (7)
and cut down the
the switch button (7) again, go on ironing.
function,
power. After fill the water tank
steam in a vertical position
supply, press the switch
there is no longer any need to
level,
again.
ironing,
the pump is
it means
(14), then press