Uline SANITARE H-2665 Manual Del Usuario página 9

OPERATING ISSUE
Motor will not start.
Motor suddenly stops.
Does not clean the carpet or floor.
No suction at the end of hose.
Noise from brush roll area.
Vacuum is hard to push.
Vacuum height knob will not turn.
PAGE 9 OF 30
TROUBLESHOOTING
Push plug securely into outlet.
Try another outlet.
Check circuit breaker.
The vacuum has overheated and triggered the thermal cutoff. (See page 2)
Push the On/Off switch to OFF (0), unplug the vacuum and check for possible
sources of overheating, such as a full dust cup, blocked hose or clogged
filter. Wait for at least 30 minutes before attempting to use vacuum again to
ensure the motor has completely cooled down.
Clean or replace the filters: Hint: If picking up fine dust, the filters may not
look dirty, but a fine substance tends to reduce suction when it blocks the
airflow through the filters.
Be sure the dust cup is properly seated into the vacuum body.
(See page 4)
Empty dust cup. (See page 4)
Be sure upper hose adapter is secure on back of vacuum. (See page 8)
Check upper hose and lower hose. (See page 7)
Replace a broken, cut, loose or out of shape belt. See page 6 for how to tell
if belt needs to be replaced.
Clean hair and thread from bristles and end cap area.
Replace brush roll if bristles are worn.
Be sure that vacuum is set to correct carpet height setting. (See page 3)
Be sure upper hose adapter is secure. (See page 8)
Clean or replace filters. Hint: If picking up fine dust, the filters may not look
dirty, but a fine substance tends to reduce suction when it blocks the airflow
through the filters. (See page 5)
Remove any clogs from the hose that restrict the airflow. Check upper hose
and lower hose. (See page 7)
Empty dust cup. (See page 4)
Remove hood and clean debris or items from the brush roll area.
Replace a broken, cut, loose or out of shape belt. (See page 6)
Put handle in operating position. Tilt the vacuum back to raise the front
wheels off floor. Then turn the knob to a higher setting.
Replace a broken, cut loose or out of shape belt. (See page 6)
Hint: Put handle in operating position. Tilt the vacuum back to raise the front
wheels off floor. Then turn the knob.
RECOMMENDATIONS
1020 IH-2665