Braun PrecisionSensor pro BP 2590 Manual Del Usuario página 10

First turn off the product. Keep the select button
pressed, until an acoustic signal sounds. The display
shows a flashing «OK» next to the position sensor
symbol (see illustration).
If you wish to turn off the position sensor, press the
«I/0» button (C): The display changes from «OK» (on)
to «–» (off). Press the memory button to confirm the
new setting. Then the product turns off
automatically. In order to re-activate the position
sensor, proceed as described above.
Storage, cleaning and disinfection of
the product
Cleaning and disinfection of the device housing and
the cuff may be done with commercially available
cleaning and disinfection solutions. Preferably
undyed solutions should be used in order to avoid
discolouring of the device housing. To clean wipe
cuff and housing with a cotton swab slightly
moistened with the solution and immediately wipe
dry with a clean cotton swab.
Do not store the product in a place exposed to direct
sunlight or high humidity.
Calibration
This product has been calibrated at the time of
manufacture. If used according to the use
instructions, periodic re-calibration is not required.
Manufacturing date is given by the LOT number on
the back of the product. The first number after LOT
represents the last digit of the year of manufacture.
The next three digits give the day of the year of
manufacture.
An example: LOT 0116 xx xx.... this product has
been manufactured on the 116th day of the year
2000.
10