Installation - oneConcept X4 Manual De Instrucciones

INSTALLATION

Before installation
• Mount the unit either inside the trunk or under a seat.
• Choose the mounting location carefully so the unit will not interfere with
the normal movements of the driver and it will not be exposed to direct
sunlight or hot air from the heater.
• Do not install the unit under the floor carpet, where the heat dissipation
from the unit will be considerably impaired.
Installation
First, place the unit where you plan to install it, and mark positions of the four
screw holes on the surface of the mounting board (not supplied), Then drill the
hoes approximately 3 mm in diameter and mount the unit onto the board with
the supplied mounting screws. The supplied mounting screws are 15 mm long,
Therefore, make sure that the mounting board is thicker than 15 mm.
Note: Tighten the screws firmly, but be careful not to apply too much force
as doing so may damage thee screws. the torque value should be less than
1 Nm.
EN
21