Technical Specifications - VONROC ET503DC Traducción Del Manual Original

EN

TECHNICAL SPECIFICATIONS

Model No.
Recommended charger
adapter
Type plug side A
Type plug side B
Number of staples/nails
Staples
Nails
Weight
Sound pressure level L
Sound power level L
WA
Vibration
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3.
1. Reload lever
2. Cartridge shaft
3. Switch
4. "0/1" switch
5. Top
6. Safety pin
7. Cartridge filling level window
8. Charger cable
9. Charging socket
10. Battery indication light
8
ET503DC
5V D.C. USB
500mA to 1500mA
USB type A
USB type C
30/min.
6 up to 10 mm
6 up to 10 mm
ca. 0.66 kg
82.2+3 dB(A)
PA
93.2+3 dB(A)
2.537+1.5 m/s
2
3. OPERATION
Charging the device (Fig. A)
• Plug the charger cable (8) (included) into an
adapter (not included).
• Plug the charger cable (8) into the machine.
(Fig. E)
• Plug the charger plug into an electrical outlet
and wait for a while. The charger indication
light (10) will lighten up and show the charging
status.
LED Charger status
Red Battery charging in progress.
Green Battery charging finished, battery fully charged.
After the battery is fully charged remove the
charger plug from the outlet and remove the small
plug from the device.
Fully charging the battery may take up to 2-3 hours.
If the red LED charging indicator starts glowing
during operation, this indicates that the battery will
soon be empty.
Application (Fig. B)
For this tool, use one of the following length for
staples or nails:
• Staples: 6 up to 10 mm
• Nails: 6 up to 10 mm
Loading the nails or staples (Fig. C)
• Choose the correct nail or staple for the job.
• Hold the tacker with bottom upwards.
• Open de cartridge shaft (2) by slightly pressing
the reload lever (1).
• Pull the reload lever backwards to open the
cartridge shaft (2).
For nails:
• Place the nails upside down against the left side
of the cartridge shaft (2). The left side also shows
a nail-symbol on the cartridge shaft, see fig.D.
For staples:
• Place the staples upside down in the cartridge
shaft (2).
• Push the reload lever to fully close the cartridge
shaft.
WWW.VONROC.COM