Operating Instructions; Care And Maintenance; Troubleshooting; Warranty - Kobalt SGY-WS5 Manual De Instrucciones

OPERATING INSTRUCTIONS

1. To open the roller stand, push in and hold the
release/lock knob and then pull out on the front of
the leg support frame until you hear the release/lock
knob lock into place. To close the roller stand, push in
and hold the release/lock knob and then pull on the
back leg support until you hear the release/lock
knob lock into place.
2. To raise the height of roller, loosen the locking
lever (B) by turning it counterclockwise. Pull up
on the roller (A) until you get to the desired height.
While holding the roller (A), tighten the locking
lever (B) by turning it clockwise. To lower the height
of the roller, while holding onto the roller, loosen the
locking lever (B) by turning it counterclockwise and
lower the height indicator bar (G) all the way down.

CARE AND MAINTENANCE

To clean, wipe down the product with a clean, lint-free tissue or cloth. Store in a dry location.
For stubborn stains, wipe down with lukewarm water. Do not submerge product in water.
Make sure all connections are tight prior to use.
Make sure the roller stand is closed and the height indicator is completely down before storing.

TROUBLESHOOTING

If you have any questions regarding the product, please call cu stomer service at 1-888-3KOBALT,
8 a.m. - 8 p.m., EST, Monday - Friday.
PROBLEM
Stand won't open or
close.
Can't raise height
indicator bar.

WARRANTY

This tool is warranted by the manufacturer to the original purchaser from the original purchase
date for three (3) years subject to the warranty coverage described herein.
For warranty questions, call our customer service department at 1-888-3KOBALT,
8 a.m. - 8 p.m., EST, Monday - Friday.
Kobalt is a registered trademark of LF, LLC.
®
All rights reserved.
POSSIBLE CAUSE
1. Release/Lock knob stuck.
2. Locking lever tight.
Height indicator bar stuck.
1
2
CORRECTIVE ACTION
Push and pull on knob until it will move
freely, spray lubricating fluid on the
assembly and try moving again.
Loosen locking lever by turning it
counterclockwise. Check to see if the tube
housing the height indicator bar is damaged.
6
PRINTED IN CHINA
kobalttools.com