English
Technical Specification
Rechargeable flashlight
Type model
Voltage.
LED.power.input.
LED.light.intensity.(at.the.distance.of.1.m).
Time.of.lighting.
Flashlight.tilt.angle.
Weight.without.battery.pack.
Weight.with.battery.pack.AP.7.LC.
Description:
1 .........Accumulator (battery pack)
2 .........Accumulator clamp
3 .........Push button switch
4 .........Spherical reflector
5 .........Charger
6 .........Charging shafts (compartments)
7 .........LED pilot lamps
Displayed or described accessories may not become the
integral part of delivery!
Putting into operation
Insert the charged battery pack (1) into the rechargeable
flashlight battery pack compartment as far as the stop.
(Click of the engaged clamps can be heard (2)). When tak-
ing the battery pack (1) out of the rechargeable flashlight,
press the clamps (2) on both sides of the battery pack and
then take the battery pack out of the rechargeable flash-
light pack compartment.
By depressing the push button switch (3) the flashlight will
go on. By repeated push button depressing (3) the flash-
light will go off.
Attention!
LED with a high light intensity is used as the light source.
Avoid direct sight into the light source - this is applicable
to yourselves as well as to other persons (and/or animals)
in your close vicinity. The risk of dazzling and thus injury of
the dazzled person (and/or dazzled animal) is imminent.
The flashlight reflector (4) can be tilted within the range of
0° to 90°, in 30° steps.
Maintenance
Instructions for flashlight cleaning
Clean the external plastic parts by a wet rag and mild
detergent. Though these parts are made of the materials
resistant to solvents, NEVER use any solvent.
Storage
The packed device can be stored in a dry unheated store
room where the temperature does not drop below –5 °C.
Store the unpacked device in a dry store room where the
temperature does not drop below +5 °C and where abrupt
temperature changes are prevented.
6
AS 7
7..V
1.W
8.500.lux
ca.8..hr
0°;.30°;.60°;.90°
0.17.kg
0.3.kg
Environmental protection
El. tools, accessories and packaging should be collected
for subsequent recovery, recycling and environmentally
sound disposal.
For EU countries only:
Do not dispose the el. tools as the home waste!
In conformity with the European Directive 2002/96/EC on
waste electrical and electronic equipment and its imple-
mentation in national legislations the unusable disman-
tled el. tools should be collected for subsequent recovery,
recycling and environmentally sound disposal.
Warranty
We grant warranty for material or workmanship defects
of our devices in conformity with mandatory provisions
of the relevant country, but 12 months as a minimum. The
warranty period of 24 months is valid in the EU countries
in case of the exclusively private scope of use (proved by
invoice or delivery note).
There is a 6-months warranty for battery cell.
The damages following from natural wear, overloading,
incorrect handling and/or the damages caused by the user
or by using the device contrary to the operating manual
or the damages known upon purchase are excluded from
the warranty.
The complaints can be admitted only if the device is sent
back to the supplier or to the Authorized Service Center
NAREX in the non-dismantled state. Keep the operating
manual and proofs of purchase safely.
Otherwise the current warranty conditions and terms of
the manufacturer are always valid.
Changes are reserved