Steren COM-890 Manual De Instrucciones página 7

7. Connect the DC end of the AC Power adapter to the DC
power input socket of the print server and the AC end to the wall
outlet. This will supply power to the print server immediately.
This print server is built with a default IP Address. To This print server is built with a default IP Address. To T T
prevent from any confl ict in your network, it is prevent from any confl ict in your network, it is p
recommended to use the PS-Utility program to change the recommended to use the PS-Utility program to change the r
IP setting when there is some other device's IP Address is IP setting when there is some other device's IP Address is I
the same as the print server's default IP Address. the same as the print server's default IP Address. t t
USING THE UTILITIES
This chapter describes the software utilities for the print server,
including how to set up your print server with these utility. The
PS-Utility and PS Wizard are designed with a user-friendly
interface that allows you to set up and administer the print server
easily.
AUTO-RUN INSTALLATION
Insert the Installation CD-ROM into your computer's CD-ROM
drive to initiate the Auto-Run program.
• User's Guide
Click to preview the User's Guide in PDF format for detailed
information of the Wireless Print Server.
• Install Utility
Click to install PS-Utility. Please refer to the next section for
detailed information on installing the utility.
• PS Wizard
Click to launch the Printer Wizard program, which is helpful to
set up the printer confi guration easily and quickly.
• PS Monitor
Click to install PS Monitor program into your system.
• Browse CD
If you want to browse the contents of the Installation CD-ROM,
click this button and the contents of the CD will be available for
preview.
• Exit
Click to close the Auto-Run program.
ENGLISH-7