Kobalt KXDD 1424A-03 Manual De Instrucciones página 11

OPERATING INSTRUCTIONS
6. Adjustable Torque
The torque clutch can be adjusted to among 23
driving settings and 1 drilling setting.
Adjust the torque by rotating the adjustable torque
clutch (B). The higher the torque setting, the more
force the drill/driver produces to turn an object.
The proper setting depends on the job and the
type of bit, fastener, and material you will be using.
In general, use greater torque for larger screws.
If the torque is too high, the screws may be
damaged or broken.
Select the drill mode
heavy-duty applications.
CAUTION
• Do not change the torque setting when the tool is running.
7. LED Work light
The LED work light (F), located on the base of
the drill/driver, will illuminate when the variable-
speed trigger switch is depressed. This provides
additional light on the surface of the workpiece for
operation in lower-light conditions.
The LED work light will turn off after approximately
10s when the variable-speed trigger switch is
released.
a. The LED work light will blink rapidly if the
tool has stopped working in order to protect
internal circuits; please wait for the tool to cool
down, at which point it can be started again.
b. The LED work light will blink slowly to indicate
that the battery charge is very low.
8. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (H) with the hole on
the base of the drill/driver.
b. Tighten one screw (I) securely with a Phillips
screwdriver (not included).
c. To remove the belt clip, use a Phillips
screwdriver to loosen the screw holding the
belt clip to the drill/driver.
for drilling and other
6
B
7
8
H
11
F
I