OPERATING INSTRUCTIONS
Used as a USB Power Supply
Your PP15 can be used to power or recharge a wide variety of small electronic devices.
1. Connect your device's charging cable to the device.
2. Connect the USB end of the charging cable into the PP15 USB port.
3. Press the Status/Power Button on the front of the unit to activate USB charging.
Used as a 12VDC Power Supply
Your PP15 can be used to power a variety of 12VDC accessories using a 12V Adapter.
1. Connect the pin jack at the end of the 12V adapter cord to the PP15 output port
marked "12V, 10A."
2. Connect the male end of the 12V adapter to the devices to be powered/charged.
3. Press the Status/Power Button on the front of the unit to activate USB charging.
Used as a Flashlight
To turn on the LED Flashlight, press and hold the Status/Power Button for three seconds.
Each successive push of the button will change the light pattern from solid to strobe to
SOS to off.
Used as a 12 Volt Jump Starter
Note: For optimum performance, do not store your PP15 below 50°F when using as a
jump starter. Never charge or jump start a frozen battery.
Note: When using as a jump starter, make sure that the unit is charged such that at
least 2 Blue LEDs light when the Status/Power Button is depressed. Your CarStart is an
essential tool for all who replace automobile batteries.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eyewear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Connect output cables/clamps to the PP15 through the covered port showing a car
and marked "Cable Input." Be sure that the cable connection is fully engaged and
secure.
5. Turn ignition off before making cable connections.
6. Clamp the positive (red +) clamp to the positive terminal on the vehicle battery (for
negative ground system), or an alternate vehicle starting point as recommended
by vehicle manufacturer.
All manuals and user guides at all-guides.com