Changing And Adjusting The Saw Blade - Bohle DIAMANTOR TG H200 Instrucciones De Uso

3) Press the water sponge into the grid plate. Then
fill the water tray of the grinder with water. This
will keep the saw blade constantly moistened. Any
splashguards must be removed.
02 Preparation of the
DIAMANTOR Band
Saw Attachment
4) Set the worktable in place and fasten it with the 2
knurled screws.
5) On the underside of the saw attachment is a pin, 10
mm long. When mounting the band saw onto the
grinder, make sure that the pin is inserted into the
sleeve.
With"KRISTALL" grinders the drive cone will be on the
transparent blue side of the band saw.
With "GLASTAR", "GRYPHON" and "INLAND" grin-
ders, the drive cone will be on the opposite (white)
side.
12
6) Swivel the band saw attachment so that the drive
roller touches the drive cone. Fasten the elastic band
so that it stretches from the lateral pin to the grid
plate. This will create a constant pressure onto the
drive cone.
The on/off switch of the grinder is used to turn on the
band saw.
03 Changing and Adju-
sting the Saw Blade
7) First loosen the two
knurled screws beneath
the worktable and remove
the worktable. Next, loo-
sen the knurled screws of
the white hood and remo-
ve the hood. Now press
the upper band roller
downward to remove the
saw blade.