VICAIR ADJUSTED O2 Manual De Usuario página 4

Alternative cushion covers:
Comfair Cover: Top: Knitted Polyester fabric.
Sides: Polyester 3D Mesh fabric. Bottom:
Polyester fabric with polyurethane anti-slip
coating.
Incotec Cover & Reversible Cover: Top: Knitted
Polyester fabric, coated with fluid resistant
breathable polyurethane. Bottom: Polyester
fabric with polyurethane anti-slip coating.
All covers: Machine washable. Covers comply
with EN1021-1, 1021-2 and CAL117.
PRECAUTIONS AND SAFETY
INSTRUCTIONS
A Vicair wheelchair seat cushion may only be
used as a wheelchair seat cushion. The use of
this product in any other way, is considered to be
misuse. Vicair B.V. cannot be held responsible
for damage caused by misuse, improper use or
negligence. Make sure that you read and
understand this manual completely.
Warning! Vicair B.V. recommends to install the
Vicair Adjuster O2 under direct supervision of a
therapist or technical advisor.
Warning! Your tailbone and pelvic bones should
not touch the bottom of the cushion. Checking
for "bottoming out" should be done during first
use and after adjustments to the cushion filling.
Warning! Check your skin regularly for redness,
especially during the first few days. If redness
occurs and does not disappear after 15 minutes,
consult your therapist or technical advisor.
Warning! Vicair B.V. recommends to adjust the
filling grade under the direct supervision of your
therapist or technical advisor.
Warning! No testing data is currently available
about the safe use of Vicair wheelchair cushions
in motor vehicles. Therefore we do not
encourage using the wheelchair cushion in
motor vehicles.
Warning! In case of soiling with body fluids, and
when transferring the product to another user,
4
the product must be disinfected to avoid cross
contamination.
Warning! Every three months, check the product
for wear and deflated cells. In case of serious
damage, or a large number of deflated cells, do
not continue to use the product. Consult your
dealer.
Caution! Do not use or leave the product close to
a naked flame or a high temperature heat source.
Caution! Do not steam clean or autoclave the
product. The product cannot withstand
excessive heat or pressure. When the given
cleaning instructions are not followed, it is very
likely that the product and/or the product's cover
will age more rapid.
Caution! Do not use aggressive or abrasive
cleaners, or sharp objects to clean the cushion.
Caution! Do not place the topside of the Vicair
O2 cushion against the glass of the washer door.
Caution! Make sure the cushion cannot interfere
with the wheel spokes.
INSTALLATION
Warning! Vicair B.V. recommends to install the
Vicair Adjuster O2 under direct supervision of a
therapist or technical advisor.
Caution! Make sure the cushion cannot interfere
with the wheel spokes.
Notice! Always use cushion with cover.
Notice! Make sure that the wheelchair seat is
clean and degreased.
Tip: When you prefer not to use the Velcro, you
can remove the Velcro strips. Note that the strips
confected to the bottom of the cushion and/or
cushion cover cannot be removed.
Perform the following steps when using the
O2 Top Cover
These steps correspond to installation images
1-6 on the Quick Installation Guide:
• Check cushion size. Width (X) of the cushion
and seat should match. When the cushion
rests against armrests or side-guards, the
E N