Publicidad
The Finest Lifestyle Truck Tops
Fitting Intructions.
GB
Fitting Intructions
GB
Montageanieitung
D
Montagevoorschrift
NL
Intructions de montage
F
Intrucciones de montaje
E
Schema di montaggio
I
Manual
S
RUS
Fitting Intructions for
WorkStyle Edition MK.2
Double-Cab / Extra-Cab
Fitting Kit
45 min
M8 x 90 x 1.25
M8 x 1.25
1) With both the vehicle's tailgate and Truck Top's tailgate closed using 2 people lift the
Truck Top on to the bed. Line up, lifting the top far forward so the Truck Tops glassed rear
door touches the vehicle's tailgate.
Check position around rear seal front & sides.
2) Open both tailgates & climb inside, clamp down firmly (without over tightening) in
position on all six points. Check again the Alignment on the outside & check the
tailgates close without fouling the rear door retaining catches may need adjusting on the
inner pillars (two bolts) so as the door catches securely at both side.
Do not over tighten.
3) Fit the 6 oval shaped rubber grommets to cover the fittings.
4)
Fitting of the rear door corner seal
ensuring the Truck Top is reasonably waterproof. Clean off the paintwork with
metholated wipe or similar & adhere as illustrated. These must be adhered correctly.
5)
Wiring
– We recommend using a qualified auto-electrician:
Drill a small (approx: 8mm) hole in the driver side Rear light cluster housing.
Pass the three wires through the hole & joint to the vehicle's wiring.
Use care and cut the cable tie which holds the wires.
Do not pull as this will rip the head lining.
6) Check tightness of the clamps periodically.
Required tools
x 6
- the two shape corner rubbers are essential in
13 mm
All rights reserved to modify the text
www.avengertop.com
3
Publicidad
