Timer Function; Overheat Protection; Cleaning And Maintenance - EDM 07214 Instrucciones De Uso

INSTRUCCIONES IMPORTANTES DE SEGURIDAD
07214
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
Warning:
Before removing the plug from the socket, switching off and before work for 30-60 seconds for cool down condition
that protecting inner parts.

TIMER FUNCTION

This function will work in any mode. The time function allows you to set the length of operation from 1 hour to 8 hours.
Press the time button in the control panel, press one time will increase the length of operation by 1 hour, most 8 hours.

OVERHEAT PROTECTION

The heater is protected with an overheat protection that switches off the appliance automatically in case of overheat
e.g. due to the total or partial obstruction of the grids. In this case, unplug the appliance, wait about 30 minutes for it to
cool and remove the object which is obstructing the grids. Then switch it back on as described above.
SAFETY CONTROL
To avoid damage and danger by overheating, your heater is fitted with super protector that switch as off the heater in
the event of overheating until the temperature drops to some extent.

CLEANING AND MAINTENANCE

1. If you don't use the heater for a long time, please wipe the surface and put it into the box. Lay the carton on the
ventilated and dry place. Humidity and force press was prohibited.
2. Wait for the machine being cool and pull out the plug, then clean it. Wipe it clean with wet washcloth or cleaner.
Never directly wash with water, do not drop the water into the machine. Never clean it with acids, chemical thinner,
gasoline, benzene etc.
3. Before use it again, please check it and make sure the outlet ventilation have no any sundries.
REMOTE INSTRUCTION MANUAL
Operation steps:
" "
Press the button the power will be on , the pilot lamp will be on and cold wind blows out.
Press again, the power will be off.
"MODE"
You can select 2 powers 1000W/2000W through this button.
"TIMER"
press the button setting time， 8 hours at most , it can be showed by the display screen..
"+" and "-"
During using, press '+'& '-' controlling temperature. When the room temperature rises to the regulation temperature,
heater will stop heating. When room temperature descend lower by 3ºC than regulation, heating up again. Regulate
temperature by '+' '-'. Start-up again, first time press '+' '-', the temperature start from 25ºC (then change according to
last regulation temperature).
-7-