Battery Charging - FITFIU FITNESS FLYING Manual Usuario

COMMISSIONING AND USE
ATTENTION:
• Before using the product, make sure that all parts of the product are tight and undamaged.
Check that the LCD display does not show a fault message. If there is a malfunction warning, do
not drive the scooter until the problem is resolved.
• Please make sure to use protective equipment to avoid possible damage.
• Make adjustments before driving.
1. After everything is ready, press the power button for about 3 seconds to turn on the scooter. After starting,
you can drive without any configuration or make the desired settings to use the product according to your
own preferences.
2. There are three types of speed, select the desired speed. It is recommended that you choose the lowest
speed mode when using for the first time.
3. After selecting the speed, place one foot on the scooter, place your right finger on the throttle lever and your
left finger on the electronic brake lever. Then press the throttle lever and the scooter will move forward, then
place both feet on the scooter and move the handlebar to turn right or left.
4. To brake, slow down and squeeze the brake lever (if you are going at a high speed, press the lever gently). To
brake more progressively you can step on the foot brake and the scooter will slow down more slowly and
smoothly.

BATTERY CHARGING

1. Make sure the scooter is turned off.
2. Insert the battery charger connector into the charging port.
3. Connect the charger to a standard power supply. When charging, the indicator will light red. The charger may
heat up during recharging, this is normal and does not have to be a cause for concern.
4. When charging is complete, the charger indicator will turn green. Disconnect the charger from the power
supply and remove the battery connector from the charging port.
NOTE: The battery has to be charged before the first use. It takes approximately 5 hours to
charge the battery from discharged to fully charged.
MAINTENANCE
ATTENTION: Make sure the scooter is turned off before starting any maintenance work.
•
Clean the scooter using only a soft dry cloth.
• DO NOT use chemicals, solvents, abrasives, or any type of liquid to clean the scooter because they may damage
electrical components or surface finishes.
•
Do not use a high pressure water gun to clean the product.
36