TowSmart MARINE SWIVEL Instrucciones De Instalación

READ ALL WARNINGS AND INSTRUCTIONS BEFORE INSTALLATION
WARNING: AT NO TIME SHOULD THE SAFE WORKING LOAD OF THE MARINE SWIVEL JACK BE EXCEEDED. THE SAFE WORKING LOAD FOR
THE MARINE SWIVEL JACK IS 1000LB (454KG) MAX CAPACITY.
WARNING: BEFORE EACH USE, INSPECT MARINE SWIVEL JACK AND MOUNTING HARDWARE TO ENSURE PROPER ASSEMBLY AND FOR ANY
DAMAGE. IF ANY PART IS DAMAGED, DO NOT USE. REPLACE COMPONENTS IMMEDIATELY.
WARNING: DO NOT USE IF WORN, BENT, OR DAMAGED IN ANY WAY. BREAKING OF JACK COULD CAUSE SERIOUS DAMAGE TO SURROUND-
ING AREAS, SERIOUS INJURY, AND/OR DEATH.
WARNING: DRAW IN JACK FULLY AND ROTATE UP OUT OF POSITION BEFORE TOWING.
WARNING: BEFORE EXTENDING JACK, CLEAR SURROUNDING SURFACE AND KEEP CLEAR FROM THE CASTER AS IT APPROACHES AND
TOUCHES THE GROUND.
WARNING: LOWER JACK AS LOW AS POSSIBLE BEFORE MANUALLY MOVING ATTACHED OBJECT.
WARNING: USE ON LEVEL SRUFACE.
WARNING: SECURE CASTER FROM MOVING WHEN JACK IS ENGAGED. JACK IS NOT INTENDED TO BE USED FOR TRANSPORTATION. MINI-
MIZE MOVEMENT OF OBJECT AFTER JACK IS IN USE.BEFORE CRANKING THE HANDLE, ENSURE RATCHET PAWL IS ENGAGED. IF TWO HANDS
ARE NEEDED TO CRANK, MAX CAPACITY OF WINCH MAY BE OVERLOADED.
WARNING: CHECK MARINE SWIVEL JACK BEFORE, DURING, AND AFTER MOUNTING AND USE. CHECK THE JACK AND MOUNTING HARDWARE
REGULARLY.
WARNING: ENSURE SPRING PIN IS ENGAGED BEFORE, DURING, AND AFTER USE OF MARINE SWIVEL JACK.
WARNING: ANNUALLY OIL/GREASE MOVING PARTS TO PREVENT RUST BUILD UP. MOVE PARTS WHILE APPLYING OIL/GREASE TO ENSURE
ALL AREAS LUBRICATED EVENLY.
INSTALLATION:
1. ASSEMBLE JACK HANDLE AND CASTER AS SHOWN IN FIGURES 1 AND 2, RESPECTIVELY. TIGHTEN LOCKING NUT TO A TORQUE OF
25FT-LBS (34N-M). DO NOT OVER TORQUE.
2. POSITION JACK ALONGSIDE THE TONGUE IN DESIRED LOCATION (FIGURE 3). MOUNT BRACKETS TO THE OTHER SIDE.
ASSEMBLE SCREWS, LOCKING WASHERS, AND NUTS AS SHOWN IN FIGURE. TORQUE TO 25FT-LBS (34N-M).
FIGURE 3
THE ATTACHMENT AND INSTALLATION OF THIS PRODUCT IS CRITICAL AND BEYOND THE CONTROL OF WINSTON PRODUCTS, LLC.
WINSTON PRODUCTS, LLC IS NOT RESPONSIBLE FOR ANY DAMAGE THAT COULD RESULT FROM IMPROPER USE, INSTALLATION, OR
ATTACHMENT. AT NO TIME SHOULD THE SAFE WORKING LOAD OF THIS PRODUCT BE EXCEEDED.
®
MARINE SWIVEL JACK
INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACION
CONSIGNES D' INSTALLATION
FIGURE 1
FIGURE 2
DO NOT OVER TORGUE
PART #791