Publicidad
Idiomas disponibles
Idiomas disponibles
Level
Align bracket to wall and
attach using appropriate
hardware (NOT included).
1
Remove cover plate and the appropriate
knock-out opening and feed the power
leads through the hole. Connect the
supplied wire from the source to the driver.
Make sure all wires are tucked in before
attaching cover plate to junction box.
Clamp
connector
Wire Color Code
White for Neutral
Black for Line
Yellow Green for Ground
Global
LED Flood Light
™
Note: Select the best access
point for your installation
1
H1
H2
H4
3
2
2
H3
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Assembly Instructions
2
Publicidad
