Vii. Follow Me; Fahrenheit Or Celsius (F/C); Ix. Time And Day Set Up; 7-Day Programming - RV Products AIRXCEL Coleman-Mach 47000 Serie Instrucciones Operativas Y De Mantenimiento

Auto: The unit will automatically heat and cool, depending on the set point temperature. (Heating only
functions on air conditioners with electric heat, heat pumps or vehicles with an auxiliary source of heat, e.g.
a gas furnace). Use the UP & DOWN buttons to select the desired set point temperature. In the Auto
mode, the fan speed is selected automatically. To advance to the Dry mode, press the MODE button.
Dry: This mode is for dehumification when the vehicle is not in use. The unit will operate in the cooling
mode to provide dehumidification. Use the UP & DOWN buttons to select the desired set point
temperature. If the room temperature in is above the set point, the unit will operate for 15 minutes and then
turn off for 3 minutes. If the room temperature is below the set point, the unit will operate for 6 minutes and
then turn off for 15 minutes. In the Dry mode, the fan speed is selected automatically. To advance to the
Fan mode, press the MODE button.
FAN: The indoor fan is run to circulate air, but the compressor does not operate. In the Fan Mode, two fan
selections are available: High speed continuous or Low speed continuous. Use the FAN button to select.

VII. Follow Me

In normal operation a temperature sensor in the ceiling assembly senses the temperature and controls the
operation of the Air Conditioner or Heat Pump. Follow Me switches this control to a temperature sensor on
the hand held controller. To activate Follow Me, press the Follow Me button for 3 seconds and release. On
or Off will flash on the screen. Press the Follow Me button again to change the setting. In Gas heat mode,
Follow Me is automatically turned on.
VIII. F/C
Selects whether the temperature is displayed in Fahrenheit or Celsius. Press and hold the F/C button for 3
seconds and release. CEL or FAH will be displayed. Press the F/C button again to change the selection.

IX. Time and Day Set Up

Press the CLOCK button and hold for 3 seconds.
The hour and AM or PM will flash. To change the hour, press the UP or DOWN button.
To change the minute, press and release the PROGRAM button. To change the minute, press the UP or
DOWN button.
To change the day, press and release the PROGRAM button. To change the day, press the UP or DOWN
button.
Press the CLOCK button to return to the normal screen.
X.

7-Day Programming

The 7-day program schedule allows different set point temperatures for different times of each day of the
week. The schedule includes four periods– Morning, Day, Evening and Night- for each day of the week.
Each period has a start time, a set point temperature for Heat, Cool and Auto modes. For 7-day
programming:
Press the CLOCK and PROGRAM buttons simultaneously and hold for three seconds.
The first selection is for the day of the week. Press the UP or DOWN button to select Monday (MON).
Press the PROGRAM button to select the settings for the Morning period. Press the UP or DOWN button
to select Morning.
Press the PROGRAM button to select the hour for the period to begin. Use the UP and DOWN button to
select the hour.
Press the PROGRAM button to select the minute for the period to begin. Use the UP and DOWN button
to select the minute.
-6-