Behringer EUROPOWER PMP2000D Guia De Inicio Rapido página 15

(26) AUX IN section accepts audio signals
from external devices using 1/8" TRS
stereo connectors. The AUX IN knob controls
the input level.
(27) Use the FX FOOTSW(itch) jack to connect
any commercially available foot controller.
It allows you to bypass the effects unit.
(28) Here, you will find a list of all multi-effect
presets available.
(29) This is the LED level meter of the effects
processor. Please make sure that the clip
LED lights up with signal peaks only. If it is
lit constantly, this indicates that the effects
processor is overdriven, which can lead to
unpleasant distortion.
(30) The Effect display reads the currently
selected preset.
Turn the PROGRAM/PARAMETER [PUSH]
(31)
control to select the effect presets. Press the
control briefly to confirm your selection.
PUSH and TURN the button to adjust one
parameter of the currently chosen effect.
(32) FX button activates the effects processor
when pressed.
TAP button allows you to program time-based
(33)
effects (such as delay) by pressing the button
repeatedly in time with the desired tempo.
The TAP LED flashes rhythmically to show the
current tempo.
(34) The mains connection is on a standard IEC
receptacle. An appropriate power cord is
supplied with the unit.
(35) Use the POWER switch to put your PMP2000D
into operation. The POWER switch should
always be in the "Off" position when you are
about to connect your unit to the mains.
(36) SERIAL NUMBER.
(37) OUTPUT A uses pins 1+ and 1- to send out
the left (LEFT) speaker channel over a single
2-pole speaker cable. As an option, you
may also connect a single 4-pole speaker to
OUTPUT A to carry both the left and right
speaker outputs, in which case the left
channel output will use OUTPUT A pins 1+
and 1-, while the right channel uses OUTPUT A
pins 2+ and 2-. When the POWER OUTPUT
switch is set to BRIDGE/BRIDGE mode, the
bridged mono output uses pins 1+ and 2+ of
OUTPUT B only (using a single 2-pole speaker
cable), and you should therefore NOT connect
any speaker cable to OUTPUT A.
(38) OUTPUT B uses pins 1+ and 1- to send out
the right (RIGHT) speaker channel over a
single 2-pole speaker cable. When the POWER
OUTPUT switch is set to BRIDGE/BRIDGE mode,
the bridged mono output uses pins 1+ and
2+ of OUTPUT B only (using a single 2-pole
speaker cable), and you should therefore
NOT connect any speaker cable to OUTPUT A.
15
Quick Start Guide