Transport And Storage Of Cordless Tools - Hilti PM 30-MG Manual De Instrucciones Original

• Have the product checked by Hilti Measuring Systems Service after exceptionally heavy use or subjection
to unusual conditions or stress, before important work or at least once a year.
Testing and inspection by Hilti Measuring Systems Service does not relieve the user of the obligation to
check the scanning tool before and during use.
7

Transport and storage of cordless tools

Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The tool can't be switched
on.
Individual laser beams don't
function.
The tool can be switched on
but no laser beam is visible.
Automatic leveling doesn't
work.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
*2243556*
Printed: 08.05.2019 | Doc-Nr: PUB / 5492771 / 000 / 00
Possible cause
The battery is low.
The battery is not fitted correctly.
Device or selector switch faulty.
The laser source or laser control
unit is faulty.
The laser source or laser control
unit is faulty.
The temperature is too high or too
low.
The tool is standing on an exces-
sively inclined surface.
Selector switch in the
The inclination sensor is faulty.
2243556
Action to be taken
▶ Charge the battery.
▶ Fit the battery and check that
the battery is securely seated in
the tool.
▶ Have the tool repaired by Hilti
Service.
▶ Have the tool repaired by Hilti
Service.
▶ Have the tool repaired by Hilti
Service.
▶ Allow the tool to cool down or
warm up.
▶ Set the device on a flat,
horizontal surface.
▶ Set the selector switch to the
position.
position.
▶ Have the tool repaired by Hilti
Service.
English 19