Ltc Audio CDM100-BL Manual Del Usuario página 5

LOUDNESS
Press LOUDNESS button to enhance the bass level immediately when bass is not enough.
FUNCTION
Press successively the FUNCTION button to adjust VOLUME, BASS and TREBLE at your convenience. Press FUNCTION
once if you want to adjust the volume, twice to adjust the bass and 3 times to adjust the treble.
CD / MP3 OPERATION
You can play in your Micro System your audio CD and MP3, CD -R. Please do not try to play CD-ROM, CD -I, VCD or
DVD.
1. Open the disc tray by pressing OPEN/ CLOSE button on the unit or on the remote control.
2. Insert the CD with the printing side facing up and close gently the disc tray by pressing again OPEN/ CLOSE.
3. Press SOURCE button to select the CD MODE.
4. Press to start the CD playback; for AUDIO CD, playback starts automatically.
5. Press stop button on unit or on remote control to stop playback.
Searching for a section within a CD (On Remote Control Only).
During playback, press and hold / on the remote control to find a specific passage within the track and release it
at the point you want to listen to.
Select another track or fi le
Press  or  button on the remote control to select a particular track.
Listening to your tracks (files) repeatedly (On Remote Control Only)
1. Press REPEAT button repeatedly to activate the REPEAT function in following order:
REPEAT 1 -REPEAT ALBUM (*MP3 MODE ONL Y) - REPEAT ALL - OFF -
Listening to your tracks (files) randomly (On Remote Control Only)
1. Press RANDOM button to play tracks in a random order.
A-B function (On Remote Control Only)
During CD/MP3 DISC playback, you can press A-B button on remote to start from the point A (time point you
pressed), and ended point B when you press A-B button again and music will play repeatedly from A to B.
Intro function (On Remote Control Only )
This feature allows you to play the 10 first seconds of each track on the disk.
Load the disc and wait until the display shows the total playing time and number of tracks. Press INTRO button on
remote control to activate the function, press again to cancel the function.
PROGRAM
Creating your own playlist
You can play up to 20 tracks on a CD in order.
1. Insert a CD and wait for to be read
2. Press PROG button on the remote control in STOP status.
3. Press /  on the unit or on the remote control to select the track you want to program. Press PLAY button on
remote or on front panel of the unit to confirm your selection.
4. Press on the unit or on the remote control to play the programmed music files.
About MP3
MP3 Disc compatibility with this unit is limited as follows
Sampling Frequency: 32-48 (MP3)
Bit rate: 32-320kbps (MP3)
Do not use special letters such as / :*?< > etc
Even if the total number of files on the disc has more than 1000, it will only be shown up to 999.