Westinghouse SR58FA A-08 Manual De Instrucciones

FOR FIRST TIME USE: SOLAR LED LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8 -12 HOURS WITH THE SWITCH IN
THE "ON" POSITION TO ALLOW THE RECHARGEABLE BATTERIES TO REACH MAXIMUM CAPACITY.
Tools Required
Pencil Phillips-head
Screwdriver
1
Marking the location
Mark the location where you want to mount the light fixture (Part C) .
Measure the width of two holes on the back of the solar fence
light to align holes for the 2 screws (Part A) on the surface. The
distance between the two holes is 3.9in. (100mm).
Drill two holes.
2
Mounting the light
wall anchors Part
Insert the (
Part
Insert the screws ( A) and leave at least 1/4in. (6.5mm) of the
Part
screws ( A) outside of the surface for holding the light
(Part
C).
fixture (Part
Mount the light
the keyholes on the back of the light
heads.
TROUBLE SHOOTING
If light does not turn on, remove battery,
wipe both ends with a clean, dry cloth
and reinstall battery. Check the battery
to ensure that it is making secure
contact with the terminals.
If this does not work, replace with a
new battery.
WARNING:
Do not dispose of lithium batteries in municipal waste stream or by fire as batteries may explode. Do not open, short circuit, or destroy
batteries. Dispose of batteries in accordance with Local, State, and Federal regulations. Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel cadmium, nickel metal hydride or lithium ion) batteries .
For additional help and information regarding installation, contact customer service at 1-844-551-0680, 8am-5pm, CST Monday – Friday
Electric drill
drill bit size:
ø7.5mm (3/10 in.)
B) so they are flush with the surface.
fixture
Part
C) on the screws ( A) by placing
fixture (Part
C) over the screw
Slide the power switch to the "OFF" position. Remove
the 5 screws from the battery cover using a Phillips
head screwdriver. Pull up and remove battery cover.
Remove the old battery and replace it with a new 3.7V,
2000 mAh lithium (18650) rechargeable battery.
Replace the battery cover removed earlier with
the 5 screws. Slide the power switch to the "ON"
position.
For optimum performance, allow light xture to charge
in full sunlight for 8-12 hours.
, WESTINGHOUSE, are trademarks of Westinghouse Electric Corporation. Used under license by Sky Rich Star Limited. All Rights Reserved.
INSTRUCTIONS
INSTALLATION
Hardware Included
(A)
Screw X 2
Parts
B
REPLACING THE BATTERY
customerservice@qx-usa.com
SOLAR LED FENCE LIGHT
ITEM: SR58FA_A-08
(B)
Wall Anchor X 2
(C)
Light Fixture X 1
100mm
x
A
C
ON/OFF Switch
Battery
x
A
Screws
Battery Cover
18/03/2019
E