Wall Installation - Ariston 3024173 Instrucciones De Instalación

installation
PRECAUTIONS
PRIOR TO INSTALLATION
The board is designed for wall installation.
Make sure that all module components are
intact following transport and handling,
and have not been damaged by knocks.
In case of evident damage to the product,
do not proceed with installation.
CAUTION
When drilling the wall, take care not to
damage any existing electrical wiring or
piping.

WALL INSTALLATION

After identifying a suitable wall, drill a hole
in it and insert one of the three wall plugs
provided, taking care not to damage exist-
ing electrical wiring or piping, and proceed
as follows:
- hook the control unit onto the screw po-
sitioned on the wall beforehand (fi g. 1).
- remove the control unit cover by loosen-
ing the two screws on the front (fi g. 2).
- mark the reference points for the posi-
tion of the two wall plugs (fi g. 3), drill
holes in the wall and fi t the wall plugs.
- hang the control unit on the wall and
insert the two fi xing screws (fi g. 4); be-
fore tightening them, make sure that the
entire control unit is resting against the
wall and level, both horizontally and ver-
tically. If it is not, perform the necessary
adjustments using the fi xing screws.
- close the control unit cover, tightening
the four screws on the front.
Fig. 3
Fig. 1
Fig. 2
Fig. 4
15
GB