Naxa NPB-428 Manual De Instrucciones página 7

USING THE CD/MP3
LOADING A DISC
1. Set the FUNCTION switch to CD/MP3/USB/AUX position.
2. Open the CD door.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door.
The total number of tracks will appear on the display after several seconds.
5. To remove the CD, press OPEN to open CD compartment lid, grasp the CD by its edges, and
carefully take it out.
Note:
 To ensure good system performance; wait until the disc tray completely reads the disc before
proceeding.
 If no disc is loaded into the compartment, or the disc is placed upside down, the display will show
N0D.
1. Press the PLAY/PAUSE/USB button to start playback.
The playback starts from track 1, the "
To interrupt playback, press the PLAY/PAUSE/USB button. The "
track will flash on the display.
To resume playback, press the PLAY/PAUSE/USB button again.
2. To stop playback, press the STOP button, the total number of tracks appears on the display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
 Press the CD SKIP/SEARCH FORWARD/BACKWARD button repeatedly in stop mode or during
play until the desired track appears on the display.
 Press the PLAY/PAUSE/USB button to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the CD SKIP/SEARCH FORWARD/BACKWARD button to scan the current playing
track at high speed until desired point passage, and then release the button.
Playback will start again from this point.
To select a song which track number exceeds 10
To select a song/track which number exceeds 10, Press the FOLD+/+10 button each time to skip
forward/backward 10 tracks, then press the CD SKIP FORWARD/BACKWARD button to select desired
track. For example: to select the 17
button six times immediately.
To Select A Desired Folder（for MP3 disc only）
(if the MP3 disc contains more than one folder)
To skip to the desired folder during playback, press and hold the
FOLD+/+10 or FOLD-/-10 button for about 2 seconds to skip to next/previous folder.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3 99 tracks
can be stored in the memory in any order.
1. In stop mode, press the PROG./P-MODE button, the PROGRAM will flash and the P01 indicator
will be on.
2. Press the CD SKIP/SEARCH FORWARD button to select the first desired track to be programmed.
3. Press the PROG./P-MODE button to enter. The display changes to show P02.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5. Press the PLAY/PAUSE/USB button to start playback from the first programmed track.
6. Press the STOP button to stop program playback.
Note: You can press the PLAY/PAUSE/USB button to enter the USB playing mode, follow the above
steps to proceed PROGRAM TRACKS ON USB play.
" indicator is shown on the display.
th
track, press FOLD+/+10 button, and then the CD SKIP FORWARD
6
" indicator and the current