DeWalt DCF6202 Manual De Instrucciones página 5

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Fitting the Collated Screwdriver Bit
(Fig. A, B)
NOTICE: For proper operation only use D
collated screwdriver bit (catalog #: DCF6202PH2).
1. Remove the nose cone from the screwgun.
2. To remove the bit and bit holder:
a. Grab the bit holder.
b. Push it into the gear case depressing the sleeve.
c. Rotate the bit holder until the clutch engages.
d. While holding the sleeve depressed, pull the bit
holder out.
nOTE: Refer to and follow all instructions on
changing bits and holders in your screwgun manual.
3. Push and rotate the provided collated screwdriving
bit 9 into the spindle until ball lock snaps in groove of
the bit shank.
Installing and Removing the Magazine
from the Screwgun (Fig. B)
With the the nose cone removed and provided driver bit
installed, push the magazine over the bit onto the screw
driver until the magazine clicks into place and ensure that it
does not disengage.
nOTE: Make sure the screwgun control lever is set to
forward rotation before use.
To remove the magazine, press and hold the release
buttons 8 on both sides of the accessory and pull accessory
off the screwgun.
Fig. B
9
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. C, D)



WALT Proper hand position requires one hand on the rear grip.
e
Take care to not block the air vents on the screwgun.
9
Fig. D
8
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
CAUTION: NEVER grip the collated attachment,
use it as a handle or touch the screw strips while in
operation as shown in Figure D.
Fig. C
English
3