Publicidad
X.21 MODEM ELIMINATOR
Installation of the X.21 Modem Eliminator is
straightforward and simple. Just follow these steps:
1. Open the unit by pressing the marked places
on the sides. If this is difficult, insert a small
screwdriver into the slot, where there is a small
opening. Lift the handle, gently levering the
tip of the screwdriver down. The cover will
separate without pressure.
Do not insert the screwdriver straight into the middle of
the slot, since this may break off the prongs that snap
the cover together.
2. Choose the mode of operation according to
Table 3-1 and Figure 3-1. There are two strap
selections to be made.
3. Close the unit and connect it to the computer
and terminal either directly or through an X.21
cable.
4. Check that the power supply is according to
the specifications given.
5. Plug the jack into the power plug on the side
of the unit and then insert the power supply
into the wall socket.
10
3. Installation
CAUTION
Publicidad
