HURAKAN HKN-HVN10 Manual Del Usuario página 6

EN
1.General information
1. never immerse the appliance in water.
2. never operate the appliance if there is no water in the reservoir.
3. always use the appliance on a dry, flat, teploustojchivoj, surface away from the edge. Be
careful when working with the appliance hands were dry.
THE EQUIPMENT MUST BE GROUNDED.
2.Installation of equipment
1. Before using the appliance, you must first clean the inside of the tank using a non-
abrasive detergent.
2. Place the appliance upright on a firm, level surface.
3. plug the appliance into an earthed socket, at this point, the device must be switched off.
4. Before first use, we recommend that you check whether the power supply rating of the
appliance as specified in the instructions. The power cord must be connected to the output
with independent regulation, which is equipped with protection against leakage and
properly grounded.
5. Before switching on the equipment, you must open the top cover of boiler water and fill
the tank with water.
6. Turn the power on, the light is on, and then set the temperature control to the desired
temperature.
7. Regularly remove limescale water in reservoir.
8. you should not remove the Scum under running water.
WATCH OUT:
1. ALL TECHNICAL WORK SHOULD BE PERFORMED AFTER DISCONNECTING THE POWER
SUPPLY.
2. DURING OPERATION, THE APPLIANCE BECOMES HOT.
DO NOT TOUCH IT WITH YOUR HANDS!
Note:
1. The heater must be installed in a place with sufficient air circulation, humidity not
exceeding 85%.
2. check the water level in the reservoir when the water level is reduced, add the water.
3. If no temperature limiter switches off automatically once the water boils, slowly turn
the temperature knob in the opposite direction until the temperature limiter turns off
automatically when the water boils.
4. If continually boiled water boils over 3 minutes, the user should disconnect the appliance
from the power supply to check.
5. If any malfunction in the appliance, do not dismantle the appliance yourself; all
maintenance work on the appliance must only be carried out by an authorized service.
6. do not pull the power cord with force, so as not to damage the power cord and prevent
electrical leakage.
7. unplug the power cord when not in use, the equipment for a long time.
ATTENTION: THE HEATER SHOULD BE PROPERLY GROUNDED.
6