Environmental Protection; Maintenance And Cleaning; Declaration Of Conformity - Bosch PEX 250 AE Instrucciones De Servicio

Polishing (PEX 250 AE/PEX 270 AE)
For polishing, fit the eccentric sander with an appropri-
ate polishing tool.
Select a low speed for polishing (step 1-2) to
avoid excessive heating of the surface.
Apply polishing agent crosswise or in a circular motion
with a sponge and moderate pressure and then allow
to dry lightly.
Polish the partially dried polishing agent with cross-
wise or circular motions using a lambswool polishing
bonnet.
Cleaning the polishing tools.
It is recommended to wash the polishing tools with a
mild detergent and warm water (do not use paint thin-
ning agents).

Maintenance and Cleaning

Before any work on the machine itself, pull the
I
mains plug.
For safe and efficient working, always keep the ma-
I
chine and the ventilation slots clean.
WARNING
Important instructions for connecting a new 3-
pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Strain relief
Live = brown
Neutral = blue
Do not connect the blue or brown wire to the earth ter-
minal of the plug.
Important: If the plug on the cable of this machine
must be replaced, dispose of the old plug to prevent
misuse.
If the machine should fail despite the care taken in
manufacture and testing, repair should be carried out
by an authorised customer services agent for Bosch
power tools.
For all correspondence and spare parts orders, always
include the 10-digit order number of the machine.
2 609 932 217 • (02.05) T

Environmental Protection

Recycle raw materials instead of disposing as
waste.
The machine, accessories and packaging should be
submitted for environment-friendly recycling.
These instructions are printed on recycled paper man-
ufactured without chlorine.
The plastic components are labelled for categorized
recycling.
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 50 144 according to the provisions of the direc-
tives 89/336/EEC, 98/37/EC.
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Specification subject to alteration without notice
To be fitted
by qualified
professionals only
English–4

Declaration of conformity

Dr. Gerhard Felten Dr. Eckerhard Strötgen