Flex MS 1706 FR Instrucciones De Funcionamiento Originales página 23

Wall chaser MS 1706 FR
2. Switch on the device.
3. Press the release rocker (8) and slowly
lower the milling unit and immerse into
the material.
4. Move the wall chaser in the indicated
cutting direction.
5. After making the cut, swivel the power tool
– with the motor running – all the way out
of the groove until the release rocker (8)
engages.
klqb
tÜÉå=íÜÉ=éçïÉê=íççä=áë=ëïáíÅÜÉÇ=çÑÑI=íÜÉ=íççä=
ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
6. Switch off the power tool.
7. Remove the remaining web with the
supplied web remover.
Swivelling the motor unit
To improve guiding the cut and handling,
the drive unit can be swivelled.
 Pull up the release handle (6) and swivel the
motor unit as far as it will go.
The release handle must engage in the new
position.
The user can now adopt an ergonomically
favourable posture when making a drawing
cut.
Operating instructions
To make vertical cuts, swivel the motor unit as
described previously.
Place the machine above and pull downwards.
Your right hand guides the motor unit, your left
hand pulls on the handle (7).
To make horizontal cuts, push the power tool.
Your right hand guides the motor unit, your left
hand is placed on the handle/intake flange (4).
Tips
When making cuts in a very hard material,
the diamond cutting disc may overheat and
be damaged.
 Immediately stop cutting and leave the
cutting disc to cool down at no-load speed.
A spark ring around the cutting disc and
a decreasing cutting rate are signs of a blunt
cutting disc.
23