Replacing Fuse; Technical Support - Kensington Charge & Sync Cabinet Manual De Instrucciones

Multi-Cabinet Sync Connection
1 Arrange the units in order on a secure surface.
2 Place configured iPad devices in the slots, connect the dock connector cable to the iPads
and USB ports. Push Sync switch button to "ON", LED light will appear in red.
3 Connect all units together using a USB hub (K33978WW Mobile Hub, sold separately).
iTunes will automatically detect the new searched device name.
NOTE: Adding a new iPad device to the station after the sync button has been activated will
require the sync button to be reset. Push the sync button off, and then on again to reset.

Replacing Fuse

If the Cabinet is not receiving power from an electric outlet, the internal fuse may be blown
and needs to be replaced.
WARNING! IMPORTANT SAFETY INSTRUCTIONS
Before replacing the fuse, the power switch must be turned off and then the power cord must
be removed completely.
1

Technical Support

Technical support is available to all registered users of Kensington products. Technical
Support contact information can be found on the back page of this manual.
2
T 5A/250V
5.2 X 20mm
13
K33978WW Mobile Hub
Sold separately