OMG™ Connector – A
CAUTION
Failure to turn off the non-Precision ETS
before connecting the OMG Connector
may result in excess stimulation.
3. Disconnect the proximal end(s) of the
non-Precision OR Cable Assembly and
insert it into the corresponding port on the
OMG Connector. Plug the non-Precision
OR Cable Assembly into the OMG
Connector socket(s) labeled "1-L" (left)
and "2-R" (right). If only a single lead is
being used, connect it to "1-L".
4. Place the OMG Connector in a secure
location on a flat surface so that patient
movement will not cause the connector
to fall.
5. Making sure that the Precision ETS is
OFF, connect the Precision ETS to the
two ports on the OMG Connector.
CAUTION
Failure to turn off the ETS before
connecting the OMG Connector may result
in excess stimulation.
Programming the Precision
ETS
1. Link the Precision Clinician Programmer
(CP) to the Precision ETS per the
standard procedure.
2. Use the Bionic Navigator
program the ETS.
OMG™ Connector – A
9055568-008 Rev A Page 4 of 34
Disconnecting the OMG
Connector
1. Turn OFF stimulation.
2. Disconnect the ETS from the OMG
3. Disconnect the proximal end(s) of the
Cleaning the OMG Connector
If necessary, the OMG Connector can be
cleaned using a damp cloth or tissue. Do
not use alcohol or abrasive cleaners. Do not
submerge the OMG Connector in any fluids.
Customer Service - USA
In USA, to order replacement parts, or
for answers to any questions you might
have, please contact the Customer Service
Department:
Outside USA, if you have a specific question
or issue, please contact your healthcare
professional.
Customer Service - Outside
Software to
USA
®
If you have any other questions or need
to contact Boston Scientific, choose your
locality from the contact list at the end of this
document.
Connector.
non-Precision OR Cable Assembly(ies)
from the OMG Connector.
• Phone: (866) 360-4747,
+1 (661) 949-4747
• Fax: (661) 362-1503
Boston Scientific Neuromodulation
25155 Rye Canyon Loop
Valencia, CA 91355, USA