Troubleshooting/Q&A - Panasonic TY-ER3D4MU Instrucciones De Operación

Troubleshooting/Q&A
Check the followings first. If they do not solve the problem,
please contact the place of purchase.
Cannot register a 3D Eyewear to TV.
► Does the TV support on this 3D Eyewear?
Use the 3D Eyewear with compatible TVs. (
► Did you allow more than 1 minute to elapse after setting
the unit to the device registration mode?
The registration is automatically released if you allow more than
1 minute to elapse. Set the registration with the television and
connected 3D Eyeware placed as close to each other as possible.
Images are not 3D.
► Is the TV has been registered with the 3D Eyewear?
Perform the registration with the TV to see. (
► Is the 3D Eyewear mode set to 3D?
Slide the tab once to the MODE position to change the mode between
3D and 2D.
► Are the image settings switched to 3D images?
Refer the television operating instructions.
► Individual differences may occur in which the 3D images
are difficult to see, or cannot be seen, especially in users
that have a different level of eyesight between the left
and right eyes.
Take the necessary steps (wearing glasses etc.) to correct your
eyesight before use.
The power of the 3D Eyewear turns off by itself.
► Are there any objects between the eyewear and
television?
The indicator lamp does not light when the power
switch is set to "ON".
► Is the 3D Eyewear sufficiently charged?
If the indicator lamp does not light at all, the battery is completely flat.
Perform the battery charging operation.
14
page 2)
page 10)