Tripp-Lite SRWB6210X2STR Guia De Instalacion página 2

Preparation
Wire Tray Models and Dimensions
Before proceeding with fabrication, first confirm your wire tray model and dimensions.
Model
SRWB6210X2STR
SRWB12210X2STR
SRWB6410X2STR
SRWB12410X2STR
SRWB18410X2STR
Fabrication
How to Cut Wire Trays
Notes:
• Always use side-action bolt cutters.
• Angle all cuts away from the new end.
• Cut each wire with one clean cut whenever possible.
• Remove any sharp edges to eliminate possible damage to cables.
Cut the bottom wires first with the underside of the
tray facing up in the order as shown:
2
3
Repeat as needed. For various wire cutting patterns and installation diagrams, refer to the documentation included with
the connectors and connector kits (sold separately).
Sectional View
1
4
5
6
Height Width
2 in. 6 in.
(50 mm) (150 mm)
2 in. 12 in.
(50 mm) (300 mm)
4 in. 6 in.
(100 mm) (150 mm)
4 in. 12 in.
(100 mm) (300 mm)
4 in. 18 in.
(100 mm) (450 mm)
To cut the side wires, flip the wire tray over and cut in
the order shown, starting from the top:
2
3
6
2
Depth
2x 5 ft. (2x 500 mm)
10 ft. (3000 mm) Total
2x 5 ft. (2x 500 mm)
10 ft. (3000 mm) Total
2x 5 ft. (2x 500 mm)
10 ft. (3000 mm) Total
2x 5 ft. (2x 500 mm)
10 ft. (3000 mm) Total
2x 5 ft. (2x 500 mm)
10 ft. (3000 mm) Total
1
4
5
1
4
2
3
5
6