A.E.B. 561N Manual Instructiones De Montaje página 4

1) Place the indicator in the interior of the car and in the position required by
means of the two thread - forming self - tapping screws.
2) Plug in the GREEN feeding connector carefully checking the right side.
3) Connect the BLACK wire to the mass.
4) Connect the RED wire to the 12 Volt with key (a maximum 5 A fuse is
suggested).
5) Insert BLACK connector of indicator cable and then perform the electric
connections with sensor wiring.
RED
FUSE
5 A MAX
12 VOLT
IGNITION
N.B.: to mechanically assemble and adjust the sensor, see the
instructions enclosed therein.
Do not absolutely open the Indicator box, especially when the
engine is running or the board panel is inserted. A.E.B. srl de-
clines every responsabilities for damages caused to things
or person which derive from the tampering of its own device
provoked by unauthorized persons.
The warranty certificate is available on the website AEB (www.aeb.it) in
the products section/sensors and indicators/AEB561 N
4 - 8
Installation
DO NOT
CONNECT
GROUND
General Direction
INDICATOR CABLE
WHITE
GREEN
DO NOT
CONNECT
WHITE
GREEN
Warranty
English
GROUND
GROUND
GREEN
IS561N-0 REV. 210610 - 1