Introduction; Features; Front Panel - Phonic CMx35 Manual Del Usuario

INTRODUCTION

Congratulations on your purchase of a Phonic CMx series
mixer/amplifier. These mixer/amplifiers can mix up to four
or six individual signals with power output rated at 35 or 60
Watts.
The CMx series is ideal for small sound reinforcement
systems. An additional zone 2 output with 8 ohm or 600
ohm output connections is included for versatile side fill or
multi-zone operation. Users are able to set priority VOX
operation with a variable threshold control. A phantom
power supply is included for condenser microphones.
A number of stereo RCA connectors with summed
inputs are onboard for inclusion of music sources. A
transformerisolated output connection is included with
8 ohms, 70V and 100V line output application possible.
Variable bass and treble controls are available on the
master output.

FEATURES

● Three-channel mixer/amplifier (CMx35
● Four-channel mixer/amplifier (CMx60)
● Three output operating modes: 8 ohms, 70V and 100V
● Output power of 35W or 60W (for the CMx35 and CMx60
respectively)
● Wide frequency response of 70 Hz to 18 kHz ±2dB
● Low distortion and ultra-low noise level
● Master bass and treble controls
● Music-On-Hold output connector
● Balanced channel 1 input
● Telephone paging output
● User-controlled VOX priority
● +15V phantom power for mics
● Two or three pairs of RCA input connectors
● Versatile heat and voltage protection for the amplifier
● Compact design and low weight
1
CMx35 / CMx60
All manuals and user guides at all-guides.com

FRONT PANEL

1. Input Level Controls
Controls in the input level control for the corresponding
channels.
2. Master Level Control
This controls the final output level before sending to the
output connectors.
3. Master Output Indicators
The green LED above the Master level control will light up
when the output signal exceeds -40dB indicating that a
signal is present. The red LED indicator will light up when
the output signal reaches high peaks with the potential of
causing distortion.
4. Bass Control
Turning to the right will increase the response of
lowfrequency signals (100 Hz) in your main audio signal.
Turning to the left will decrease the response of low-
frequency signals.
5. Treble Control
Turning to the right will increase the response of high-
frequency signals (10 kHz) in your main audio signal.
Turning to the left will decrease the response of high-
frequency signals.
6. Power Button and Indicator
This button turns the CMx mixer/amplifier on. When the
unit is turned on, the LED indicator will illuminate to indicate
as such. Be sure that the mixer amplifier is turned on after
all other input sources.
3
2 6
4 5
3
2
1
4 5
6
1