Tools Required - Foremost 3232C-W Manual Del Usuario

TOOLS REQUIRED

NOT INCLUDED
Level
Jigsaw
Tape Measure
Pencil
Power Drill
Safety Glasses
1/8 Drill Bit
PREPARATIONS
To ensure the base is the correct color, peel away the blue protective film from
base edges. Leave remaining film until installation is complete to protect finish.
Allow the base to reach room temperature before installation.
Read installation instructions carefully before starting project.
Keep instructions for warranty information.
Do not use plumber's putty. May result in product failure. Use a high grade silicone
caulk or latex for all necessary locations.
WARNING
When installing the Jetcoat® Shower Wall System or other wall coverings such as synthetic
composites, tile, marble, granite, etc., in conjunction with a Foremost® shower base.
The nailing flange of the base should
be attached directly to the bare studs
with backer board attached to the
studs above the nailing flange. Wall
materials are installed on the backer
board extending down in front of the
nailing flange and resting on the base.
Failure to install your base in this
configuration may cause problems with
installation of the Jetcoat® walls or
other wall covering materials.
SUPPLIES NEEDED
NOT INCLUDED
1-5/8 Flathead Screws
Wood Shims
Construction Adhesive
Mortar Compound (optional)
Drain Assembly
Silicone Caulk for Drain
NOTE: Drain not included
SHOWER
WALL
SHOWER BASE
- 3 -
BACKER
BOARD
STUD
NAILING
FLANGE