Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Lubrication:
The threaded joint on mounts should be well lubricated. If corrosive products have
accumulated on explosion-proof joints and cannot readily be removed with solvents,
the parts should be discarded and replaced. The motor-gear reducer assembly is a
sealed unit. Therefore, no lubrication is required.
WARNING EXPLOSION HAZARD: Never use an abrasive material or file to
remove corrosive products from threaded surfaces. In extremely corrosive
locations, equipment should be periodically inspected to safeguard against
unusual deterioration and possible porosity, since this could weaken the enclosure
structurally.
5)
Service
Ordering Replacement Parts and Accessories:
Consult product datasheet online for an updated list of placement parts. If this product
requires a part that is not available for purchase, your unit must be repaired or replaced.
The product's dome should be regularly inspected for scratches or chips and if damaged,
it must be replaced.
Technical Assistance:
Contact our technical support team at +1-708-587-3587 or signalsupport@fedsig.com.
Repair Service:
A return authorization is required. Contact your Authorized Distributor or Federal Signal
Customer Support. Defective products under warranty will be repaired or replaced at
Federal Signal's discretion. Lamp failures excluded.
Product Returns:
Returns require authorization from Federal Signal. Contact your Authorized Distributor
for more information on our return policy or to request a return.
2645 Federal Signal Drive, University Park, Illinois 60484
Additional translations available at www.fedsig.com
Traducciones adicionales disponibles en www.fedsig.com
Customer Support 1-800-344-4634+1-708-534-4756, iordersup@fedsig.com
Technical Support 1-800-755-7621+1-708-587-3587, signalsupport@fedsig.com
www.fedsig.com
25500043 Rev. B1 0221 Printed in U.S.A.
Publicidad
Tabla de contenido
