Metra CHTO-02 Instrucciones De Instalación página 3

Connections to be made
• Connect the Green/Purple wire to the reverse wire (if applicable).
• Plug the 16-pin harness into the CHTO-02.
From the 22-pin Chrysler harness to the aftermarket radio:
• Connect the Yellow wire to the 12-volt battery or memory wire.
• Connect the Black wire to the ground wire.
• Connect the Orange wire to the illumination wire. If the aftermarket radio has
no illumination wire tape off the Orange wire.
• Plug the 14-pin harness into the CHTO-02.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used in along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for
radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
CHTO-02
Installing the CHTO-02
• With all connections completed to the aftermarket radio, plug the 22-pin
harness into the vehicles wiring harness.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then "off" and "on"
again to test the radio.
Testing the CHTO-02
• Turn the ignition on if not already, and
then turn the radio "on" to verify that the
radio works. Check balance and fader
controls for proper operation.
• To adjust the overall volume of your
audio system, rotate the potentiometer
which is located on the 16-pin side of
the interface clockwise.
3