Anti-Frost Mode - N'oveen CH7100 Manual De Instrucciones

must be bigger than the current one).
For Celsius, cycle through Internal temperature (room temperature) is displayed every time
the appliance is started up. The temperature can be set when
the unit is in standby or heating mode. When the room temperature reaches the level set,
the heater will switch off the heaters (if the fan was on, it will not stop to work). The heater
will only start heating again when the temperature drops 2 degrees in in relation to the set
temperature. The temperature control range is from 5°C to 37°C.
Operation mode
Press the heating setting selection button to adjust the temperature:
750W/1250W/2000W/ANTI-FROST (CH7100/CH8000)
1000W/1300W/2300W/ANTI-FROST (CH9000)
Fan
Press the fan key, you can open the fan or turn off the fan (on the screen fan icon is lit).

Anti-frost mode

In the standby mode, when the room temperature is lower than 5°C the unit automatically
enters the high-grade heating mode 2000W (CH7100/CH8000) or 2300W (CH9000). When
the room temperature reaches 9°C, the heating is turned off to standby, followed by cycling.
Operating sound
The appliance emits a beep upon each operation setting.
LCD room temperature display
the appliance will stop when the temperature exceeds 1 degrees with respect to the set
temperature.
Memory
The appliance can hold the last temperature setting in its memory. This temperature will be
shown at each start-up.
If the power settings were different, start-up reset will go to those set as default.
Cleaning
Before carrying out routine cleaning, switch off the product and disconnect main power. Use
a soft, damp cloth only and do not use abrasive substances.
Note: Do not submerge any part of the product in the water.
15