Glass Breakage Sensor Information; Glass Breakage Sensor Check Procedure - Toyota RS3200 PLUS Guia Del Propietario

GLASS BREAKAGE SENSOR INFORMATION

The RS3200 P provides protection for your vehicle above and beyond entry point monitoring–it
LUS
"listens" for the noise made by tapping on, or breaking of glass. Using a microphone designed
specifically for this task, the G
helps to prevent "false alarms" from occurring.

GLASS BREAKAGE SENSOR CHECK PROCEDURE

When the RS3200 P
LUS
of the G B
LASS REAKAGE
below.
TOYOTA RS3200 P
B S
LASS REAKAGE
was installed in your vehicle, care was taken to adjust the sensitivity level
S . You may observe how it works following the procedure listed
ENSOR
1. A the system.
RM
Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not A
hatch is open.)
2. Wait until the S
TATUS
The LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
3. With the tip of a key, tap the center of the driver's door window.
Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially
in cold weather, or you may crack or break it.
A W A A
ARN WAY
T , make sure you performed the procedure correctly
RIGGERED
and try again. If you find that the system did not perform as
expected, contact your Toyota dealer for more information.
4. D the system to stop the W
ISARM
Press the unlock button on the remote control or use the key
to D the system.
ISARM
Security system
LUS
is capable of ignoring other noises, which
ENSOR
if any door, the trunk or
RM
M ' LED starts flashing.
ONITOR S
should be T
LARM RIGGERED
A
ARN
. If the A is not
LARM
A .
WAY LARM
Page 11