Preparing For Use; Installing The Charger; Charging The Appliance; Using The Appliance - Philips MiniVac FC6145/01 Manual De Instrucciones

English
8

preparing for use

installing the charger

1 Attach the charger to the wall as shown in the figure. (Fig. 2)
If you attach the charger to the wall, the space between the screw holes
has to be 12cm.
2 You can also place the charger on a horizontal surface (e.g. a table
or desk) (Fig. 3).
3 Wind excess mains cord around the reel in the back of the charger
and pass the cord through the slot (Fig. 4).

Charging the appliance

Charge the appliance for at least 16 hours before you use it for the first
time.
1 Make sure the appliance is switched off.
2 Put the adapter in the wall socket.
3 Place the vacuum cleaner on the charger (Fig. 5).
- Make sure you place the opening in the back of the vacuum cleaner
on the hook of the charger (Fig. 6).
The charging light goes on to indicate that the appliance
,
is charging (Fig. 7).
Note: The charging light stays on as long as the appliance is in the plugged-in
charger.
Note: The charging light does not give any information about the battery
charge level of the vacuum cleaner.

using the appliance

1 Push the on/off slide forwards to switch on the appliance (Fig. 8).
2 Push the on/off slide backwards to switch off the appliance (Fig. 9).