Installation; Operation - Selecta DRYTIME II Manual De Instrucciones

MANUAL DE INSTRUCCIONES CODIGO 80384 REV A
CAUTION!!! IMPORTANT FOR YOUR SAFETY
J
.P. SELECTA s.a.u.
Noviembre 2019

INSTALLATION

Place the sterilizer on a flat horizontal, level surface, leaving a
space of 15cm at the back and sides of the equipment.
Do not install the sterilizer near sunny places, heating, etc.
For an optimum operation, ambient temperature must be under
30ºC.
Do not use the incubator to dry or for thermal treatment
of products which can give off vapours capable of making
an explosive mixture.
Be sure that the voltage supply is the same as the one
indicated on the characteristics plate.
Do not use the equipment if it is not earthed.
If you change the plug bear in mind the following :

OPERATION

CONTROL PANEL:
1. Main switch/timer disconnection selector.
2. Mains indicator lamp (green).
3. Timer knob.
4. Adjustment thermostat knob.
5. Heater operation indicator lamp (yellow).
6. Analog temperature reading thermometer.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.grupo-selecta.com
(Sujetas a modificaciones sin previo aviso)
Blue cable:
Brown cable:
Yellow/green cable:
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Pag.: 9
Neutral.
Phase.
Earth.