Technical Data - Adler europe AD 9616 Manual De Uso

13. Do not use the shaver for clothes made of silk, wool or linen. This can damage the
fabrics and destroy the shaver blades.
14. Do not use the device near water, e.g. in the shower, in a bathtub
or above the sink with water.
15. When the appliance is used in the bathroom, remove the plug from the socket after use,
as the proximity of water is a hazard even when the appliance is turned off.
16. Do not allow the device or adapter to get wet. Where the device
falls into water, immediately remove the plug or adapter from the wall socket. Do not put
your hands in water when the machine is connected to the network. It must be checked by a
qualified electrician before using it again.
17. Do not hold the device or power supply with wet hands.
18. Turn off the device whenever you put it away.
19. Do not leave the device switched on or the adapter unattended when unattended.
DESCRIPTION OF THE DEVICE
1. Safety cap 2. Blade cover
3. Blade group 4. Rotary shaft
5. Power switch 6. Shaver body
7. Lint and pills bin 8. Battery compartment
BEFORE FIRST USE
Open the battery compartment (8). Insert 2xAA batteries (battery not included). Close the battery compartment cover.
BATTERY CHANGE
Remove the battery compartment cover (8). Remove old batteries. Insert new 1.5Vx2 AA batteries. Close the battery compartment cover.
NOTE: Only use with non-rechargeable batteries.
USING THE FABRIC SHAVER
1. Turn the shaver on (5).
2. Place the clothes (fabric) on flat surface, smoothen the creases and move the shaver forth and back along the fabric.
3. Resisting lint can be removed by moving shaver crosswise and then lengthwise (in cross-pattern) on one, small fragment of clothes.
4. You can remove pillings from thin clothing by folding it in multi layers, and putting it on flat, stiff cardboard.
5. In case of clothing with pattern, move the shaver along the pattern line.
CLEANING THE FABRIC SHAVER
Turn off the shaver (5). Twist the safety cap (1) anti-clockwise. Twist the blade cover anticlockwise (2). Remove the blades (3) by pulling up
(Be careful! The blades are very sharp). Clean the blade cover (2), blades (3), rotary shaft (4) with attached brush (9). Empty the knotting
and pilling tank (7). Reassemble all disassembled parts in reverse order to removal.

TECHNICAL DATA

Power supply: 2xAA (2x1,5V)
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
ALLGEMEINE SICHERHEITSBEDINGUNGEN. WICHTIGE HINWEISE FÜR DEN
SICHEREN GEBRAUCH.
SORGFÄLTIG DURCHLESEN UND FÜR DIE ZUKUNFT AUFBEWAHREN
1. Lesen Sie vor dem Gebrauch des Geräts die Bedienungsanleitung und befolgen Sie die
9. Cleaning brush
POLSKI
(DE) DEUTSCH
4