Descargar Imprimir esta página

FTK CONCEPT 90I / 120I Instrucciones De Instalación página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Before assembly:
1. Unpack the device carefully and check the status of the device. The device
must be intact. If the device is damaged, stop the installation and contact FTK
without delay.
2. Check the visual assembly instructions to ensure that all hardware required for
the assembly has been delivered. Filters are located in the extractor hood.
3. Do not mount the extractor hood if damaged. This action invalidates the
product warranty.
SUPPORT NOTES FOR VISUAL ASSEMBLY INSTRUCTIONS
This manual refers to the instructions for mounting FTK island hoods that complement the
illustrated manual for easy installation. Installation and explanations are described below:
1.
Fix the upper fastening part to the desired location on the ceiling, using the
supplied screws. Then fix the top of the vertical structure to the fastening part.
Finally attach the rest of the structure adjusting it to the desired distance.
1.1. Consider the minimum and maximum installation distances on the cooking
surface. We recommend installing the kitchen hood at the minimum
recommended distance to ensure the best performance.
1.2. Place an accessible plug near the extractor hood for connection during
assembly. Verify that the plug remains easily accessible once the device is
mounted for easy access.
1.3. Make the necessary connections for air evacuation.
1.4. When connected to a short exhaust duct, it would be desirable to place a check
valve in the duct to prevent wind from entering.
2.
Separate the structure cover components, removing the necessary screws.
3.
Install the top section of the structure cover to the structure using the screws as
shown. Then add the bottom section.
4.
Screw the bottom of the structure cover through the compensation grill.
5.
Finally, cut the structure cover profile according to the size of the adjusted
structure cover by using magnets.
Disassembling the kitchen hood
1.
Before disassembling, protect the worktop (cardboard or lid) from possible drop
parts. Disconnect the hood from the electrical system.
ISLAND HOOD

Publicidad

loading

Productos relacionados para FTK CONCEPT 90I / 120I

Este manual también es adecuado para:

Neat 900i