Assembly; Contents Of Carton; Installation - Craftsman 919.167812 Manual Del Usuario

Ocultar thumbs Ver también para 919.167812:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

All manuals and user guides at all-guides.com

Contents of Carton

1 - Air Compressor
1 - Parts bag containing:
1 - Owner's Manual
4 - 5/8" Washers
1 - Conduit Connector
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - Electric drill
Unpacking
1.
Remove all packaging.
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
Locate the air compressor in a
clean, dry, and well ventilated
area.
Located the air compressor at
least 12" (30.5 cm) away from
the wall or other obstructions
that will interfere with the flow
of air.
Locate the air compressor as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electri-
cal wiring could cause power
loss to the motor.
The air filter must be kept clear
of obstructions which could
reduce air flow to the air com-
pressor.
Anchoring of the Air Compressor
Risk of Bursting.
Excessive
Vibration can weaken the air tank
and cause an explosion. The
compressor must be properly
mounted.
N004035

ASSEMBLY

one side of the outfit when removing
the pallet because the air compressor
will have a tendency to tip.
2.
Remove and discard the (4)
screws and washers holding the
compressor to the pallet.
3.
With the help of another person
carefully remove air compressor
from pallet and place on a level
surface.
the pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.

INSTALLATION

The air compressor MUST be bolted to
a solid, level surface.
Hardware needed:
4 - Concrete anchors
4 - 3/8" Lag screw to fit concrete
4 - 5/8" Washer (supplied)
1.
Place the air compressor on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install concrete
anchors.
4.
Line-up holes in surface with holes
in air compressor feet.
5.
Place the (4) washers (supplied)
between the floor and air com-
pressor feet. If needed, solid
shims may be placed between the
washers and floor to evenly dis-
tribute weight on all four feet. See
next figure.
10-ENG
It may be necessary
to brace or support
This compressor was
shipped with oil in
(not supplied)
anchors
(not supplied)
shims (if needed)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido