Ego Power+ ST1300E-S Manual Del Operador página 7

SPECIFICATIONS
Voltage
No-load Speed
Cutting Mechanism
Cutting Line Type
Cutting Width
Recommended Operating Temperature 0°C-40°C
Recommended Storage Temperature -20°C-70°C
Weight (without battery pack)
Measured sound power level L
Max. sound pressure level at
operator's ear L
PA
Guaranteed sound power level L
(according to 2000/14/EC)
Front handle
Valuation of
vibration a
h
Rear handle
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used;In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
PACKING LIST (Fig.A1)
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A1)
1. Trigger
2. Rear Handle
3. Lock-off Lever
4. Speed Adjustment Switch
5. Soft Sleeve
6. Adjustable Front-assist Handle
7. Trimmer Head (Bump Head)
8. Bump Knob
9. Line-cutting Blade
10. Guard
56 V
11. Ejection Mechanism
High: 6500 /min 12. Electric Contacts
Low: 5200 /min
13. Latch
Bump Head
14. Battery-release Button
2.0mm Nylon
ASSEMBLY
twist line
33 cm
UNFOLDING THE SHAFT
order to avoid pinching your hands or fingers.
2.76 kg
92.1 dB(A)
until the shaft has been locked. Unfold the shaft gently,
K=1.6 dB(A)
WA
ensuring the cable inside the shaft, and lock it with two
screws by the supplied wrench (Fig. B1& B2).
72.6 dB(A)
K=2.5 dB(A)
MOUNTING THE GUARD
94 dB(A)
WA
Align the guard mounting holes with the assembly holes
and then lock the guard onto the shaft base with the two
3.3 m/s
2
screws. Make sure the guard is fixed according to Fig. C,
K=0.9 m/s
2
any reverse fixing will cause great danger!
1.9 m/s 2
MOUNTING AND ADJUSTING THE FRONT-ASSIST
K=1.5 m/s
2
HANDLE
Push the front-assist handle onto the shaft (Fig. E), then
insert the clamping block into the handle slot (Fig. F),
mount the lock pole, lock them with the wing nut (Fig.
G). The sequence is as Fig. D shown. Lastly, adjust the
front-assist handle position to make sure your front arm is
straight when using the trimmer (Fig. H) and then lock the
lever of the lock pole (Fig. I).
Fig. D & H parts description see below:
NOTICE:
upwards to point toward the top of the handle.
the soft sleeve on the shaft.
front-assist handle reliably fixed.
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1300E-S
WARNING: Do not hold the shaft at the joints in
WARNING: Do not attempt to start the trimmer
D-1 Front-assist Handle
D-2 Lock Pole
D-3 Clamping Block
The front-assist handle should be turned
WARNING:
Only fix the front-assist handle in front of
WARNING:
The tool can not be used without the
EN
D-4 Wing Nut
H-1 Soft Sleeve
H-2 Warning Label
7