INSTALLATION OF DOORKNOB
If customers want to install the doorknob according to their actual demands, do
as the following steps:
1. Unhinge the door seal in the place of installing the handle
2. Cased the screws in the appointed place
3. Fasten the door handle in the door by screwdriver
4. Refit the door seal to the relevant position
OPERATING PROBLEMS
1. Start-up:
Compressor does not start even though the desired temperature is lower than
the
temperature in the room.
Check the wall socket by plugging in any type of electrical device, and make
•
sure that the on/off switch is in the "I" position.
If the compressor still does not start after taking steps 2 and 3, contact your
•
dealer.
2. Dew on the surface of cabinet:
The surface of wine cabinet especially the glass door will appear some frost if the