MSA FlameGard 5 UV/IR-E Guia De Inicio Rapido página 2

FlameGard 5 UV/IR-E Fl
Quick Start Guide
3. Apply Power to the Detector
Two light emitting diodes (LEDs) are visible through the IR window (the right
hand side window on UV/IR unit). Immediately upon powering up the detector,
both LEDs will start blinking alternately for 10 seconds. The unit will then enter
the "Ready" mode. During the "Ready" mode, the green LED will flash off 1
second, every 10 seconds
4. Test the Detector Using the Test Lamp
Test the integrity of your system by using a FlameGard 5 Test Lamp. The
original configuration (sensitivity and relay options) can be changed by referring
to the manual.
If you have any problems in the set-up or testing of the detector, please refer to
the "Troubleshooting Section", or call the factory directly.
The instrument is now ready to operate. Please consult the manual for more
information on the instrument's many features.
GB
ame Detector
MAN5UVIRE-QG/01